How much air do you put in a mountain bike fork?

How much air do I put in my mountain bike shocks?

For the rear shock, start at about half of your rider weight for air pressure. You will have to adjust from here, but you will want to achieve the proper SAG for your frame, as recommended by your frame manufacturer. Typically this is somewhere between 30-40% of overall travel.

How much air should I put in my fork?

Setting Fork Air Pressure

Sag range should be set to 15–20% of total fork travel. Unscrew the blue air cap on top of the left fork leg counter-clockwise to expose the Schrader valve.

What psi should my FOX shock be?

Do not exceed 300 psi (20.7 bar), the maximum FLOAT air pressure! Remove the pump. Sit still on the bike in your normal riding position, using a wall or a tree for support. Pull the sag indicator o-ring up against the rubber air sleeve seal.

How much air should I put in my Fox Float shock?

Add air pressure to the main air chamber in ~50 psi (3.4 bar) increments, slowly cycling the shock after every 50 psi (3.4 bar) addition.

What PSI should my front fork be?

On the biggest stuff you hit, you should be close to bottoming or bottoming but not hard. If you’re running into not using all the travel, drop the pressure in small 5psi decrements. If you’re bottoming, raise pressure a bit.

THIS IS INTERESTING:  Question: Are sit on top kayaks better?

Do air forks lose air?

If you have a fork that uses air to provide the spring, losing pressure means the fork will get shorter and stop being responsive over bumps. Most forks use a Schrader valve on the air chamber (the same as car tires). It also relies upon the pump having clearance around the shock inflation valve. …

What psi should I run in my rear shock?

Start by setting the shock air pressure (psi) to match your weight in pounds. With the air pump attached to the shock valve, slowly cycle your shock through 25% of its travel 10 times as you reach your desired pressure. … Do not exceed 300 psi, the maximum FLOAT air pressure!