Why are my skateboard wheels stiff?

Should skateboard wheels be stiff?

Your skateboard wheels should be tight enough that they spin freely. However, you don’t want the wheels so loose that they wiggle on the truck’s axle. … It’s also possible to over-tighten skateboard wheels, and that will prevent you from getting the most speed out of your board.

Why is my skateboard stiff?

Wheels are very tight

One of the most frequent issues that produce a slow skateboard is over-tightened axle nuts. How tight should skateboard wheels be? Over-tightening axle nuts causes pressure against bearings, not allowing wheels to spin.

How do you loosen skateboard wheels?

Use the wrench to loosen the nut, but do so only slightly. Just nudge it counter clockwise and spin the wheel again. If it still comes to a quick stop, bump it backwards again. Continue doing this until each wheel rolls freely.

Why is one of my skateboard wheels spin slow?

Your board is not set up right. Make sure your axel nuts are not to tight. You should have a tiny amount of play side to side with the wheel.

Is it OK to use WD40 on skateboard bearings?

It’s important to use a silicone-based lubricant. WD40 or others like it will dry out your bearings and attract dust and dirt. … It doesn’t take much, and the excess will just spin out when you replace your shields, pop your bearings back in your wheels and start shredding. Skate safe and enjoy your new-found speed.”

THIS IS INTERESTING:  What kind of word is mountain?

Is it better to have tight or loose trucks?

The main consideration when adjusting your trucks has to do with speed. The faster you intend on riding, the tighter your trucks should be. Tight trucks provide stability at higher speeds, reducing the likelihood of catching the dreaded speed wobbles.

Why can’t I turn on my skateboard?

Check the tightness of your trucks.

If your deck barely tilts, it means you have tight trucks, which will make it difficult to turn. If your board tilts easily, it means your trucks are loose; while looser trucks make turning easier, they also make your deck unstable and difficult to control.

Why does my skateboard not go straight?

It may simply be a case of your kingpin being a bit too loose or not quite set straight, in this case you will either need to tighten it up, or straighten it up. It is also possible that some of the bolts may not be done up tight enough and the truck is twisting slightly.